is a transcriptional repressor protein responsible for the regulation of the Czr operon in prokaryotes. The best studied example to date comes from Staphylococcus aureus.

Biological Function

Operon Overview

Operons are a critical genetic component of most prokaryotic cells. There are many different operons, responsible for the production of proteins with a wide range of functions. The most well-known and studied operons are the Lac and Trp operons, responsible for producing enzymes which metabolize lactose and tryptophan respectively. Despite many differences in each operon and the proteins that they encode, operons all function in the same general manner (Figure 1). Each operon contains a regulator, an operator, and one or more structural genes. The regulator gene codes for a protein responsible for managing the expression level of the structural genes. The operator contains the binding sequence for RNA polymerase and is the site where transcription begins. Lastly, the structural genes code for proteins to be used elsewhere. The regulator protein (produced as a result of expression of the regulator gene) usually acts in a repressive manner. The regulator protein will bind to the operator gene, inhibiting the binding and/or progression of RNA polymerase to the structural genes, thus inhibiting transcription of the genes into mRNA. If the regulator protein were always active, the structural genes would never be expressed, so there must be a way to inactive the regulator protein, thus enabling expression of the structural genes. This is usually achieved through the binding of an inhibitor to the regulator protein. Since regulator proteins are DNA binding proteins, often this inhibition is allosteric rather than competitive. The inhibitor of the regulator protein binds to somewhere other than the active site of the protein, changing the conformation of the regulator protein to decrease its ability to bind DNA and repress transcription.

Figure 1: Overview of CzrA operon structure

The Czr Operon

The Chromosome determined zinc responsible (Czr) operon acts as described above (Figure 1), with CzrA acting as a regulator protein to the downstream structural gene CzrB^[1]. The CzrB gene in turn codes for a Zn⁺² pump, the CzrB protein. When relatively low amounts of zinc are present in the cell CzrA will bind to the operator on the Czr operon, preventing the progression of RNA polymerase and thus inhibiting expression of CzrB. Decreased expression of CzrB results in a buildup of Zn⁺² inside the cell, as there are fewer pumps to export Zn⁺². This metal sensing system serves to maintain an appropriate intracellular concentration of Zn⁺².

Structural Overview

Czr A functions as a dimer to repress gene transcription. Each contains seen in purple and displayed in yellow. Key helices regulate the binding of DNA versus Zn⁺². The (green) are the location of DNA binding and the (red) contain the Zn⁺² binding sites.

Allosteric Inhibition by Zn⁺²

CzrA is allosterically inhibited by the binding of two Zn⁺² ions. The structure of CzrA has been determined in two different conformations^[1]; the first has a high affinity for DNA and has no Zn⁺² ions bound to it (PDB code: 2KJB). In this conformation the . Binding of zinc drives a conformational change (PDB code: 2KJC) in which the , changing the overall shape of the protein and significantly lowering its affinity for DNA (Figure 2). Unfortunately, zinc ions are not directly visible in the 2KJC structure, which was determined by NMR spectroscopy.

Figure 2: Comparison of Czr A bound to DNA to Czr A with Zn⁺² bound. α5 helices are shown in red and the α4 helices shown in green.

DNA Binding Site

Ser54, Ser57, and His58 are the primary residues involved in with Czr A^[1]. These residues are likely to interact with the 5'-TGAA sequence found in the half-site of the DNA, where the α4 helices (green) (Figure 3). Binding of two Zn⁺² ions . Additionally, Val42 and Gln53 (lime green) are involved in the .

The Gln53 and Val42 (aqua) as well as the Ser54, Ser57, and His58 (lime) have been individually mutated to Ala, and DNA binding experiments were performed^[1]. Compared to wild type Czr A, Gln53Ala and Val42Ala variants displayed an 11-fold and 160-fold decrease in K_a, respectively. Mutations to the main DNA interaction sites Ser54, Ser57, and His58 result in drastic loss of binding similar to the inhibited non-DNA binding conformational state, suggesting that these residues are essential to binding DNA. While the conformational change that occurs from the Zinc bound state to the DNA bound state is small,the α4 helices (shown in green in Figure 2) are slightly shifted. The loss of DNA binding in the mutagenesis experiments in combination with the lack of any other major physical changes between these two states further suggests that the α4 helices are the location of DNA binding in Czr A. A (not available in the PDB) has been since been published^[2] (Figure 3).

Figure 3: Two views of Czr A bound to DNA. A segment of DNA is shown in orange with the α5 helices displayed in red and the α4 helices shown in green.

Zinc Binding Site

Many zinc-dependent proteins are transcriptional regulators^[3]. Czr A fits into this category as an allosteric inhibitor of the czr operon. Two Zn ⁺² ions may bind to the dimer^[1], at the location of the from each monomer. As zinc binds, the α5 helices to inhibit the DNA binding residues (Figure 2). Furthermore, CzrA must be in its dimer form for zinc to bind. The are formed by two residues from each monomer, so Zn⁺² cannot bind to the monomer. The is formed by Asp84 and His 6 from one monomer, as well as His97 and His100 from the other monomer. Zinc ions were not present in the solution NMR structure^[1], so a representation of a zinc ion in the binding pocket has been drawn in Figure 4. The large number of histidines used in the Czr A zinc pocket is a repetitive and commonly found feature in zinc-binding proteins ^[4].

Figure 4: Zn⁺² tetrahedral binding complex

Zn⁺² binding is driven by a large entropic gain ^[5]. Water molecules around the metal ion and Czr A protein are displaced, and gain greater freedom. This gain in entropy allows Zn⁺² to bind to Czr A with reasonable affinity and speed in vivo. The zinc⁺² ion forms a tetrahedral complex with four residues (Figure 4). Other metal ions that may form a tetrahedral complex will have some affinity for Czr A; however, the metal binding pocket of Czr A has been optimized to bind Zn⁺² with the highest affinity.